Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Driveway & Pavers: The Fort Worth Owner’s Guide
We stock and install IKO-compatible driveway and paver components across Fort Worth, with most driveway replacements running $5,000 – $14,000 and paver driveway installation at $7,000 – $18,000 depending on square footage, substrate condition, and the IKO product line you’re matching. Most owners discover a problem the same way: a paver shifts underfoot after a heavy rain, a crack opens along the IKO edge restraint, or the surface stops draining and water pools against the foundation. You call because you need the right part matched to your existing IKO layout, a firm price, and a crew that shows up.
The most common call we get in Fort Worth starts with “one paver sank” or “the edge is coming apart.” By the time a homeowner notices, the issue is usually in the base layer underneath, not the paver itself. That distinction matters because it changes the part list, the labor, and the price. Bradford Remodeling Co Fort Worth is an independent service provider, not affiliated with IKO, but we work with IKO-compatible driveway and paver materials daily and keep common replacement components on hand.
Which IKO Models This Applies To
IKO’s driveway and paver lines span permeable pavers, interlocking concrete units, and edge restraint systems that work across most residential Fort Worth lots. The compatibility issue that trips people up is paver thickness. IKO units typically run 60mm, 80mm, or 100mm, and mixing thicknesses on the same driveway creates lippage and early failure. If you’re replacing a section, not the entire drive, you need to match the existing unit’s thickness, not just its surface pattern.
To identify which IKO product you have, look for the manufacturer’s stamp on the underside of a lifted paver, or check the original invoice from when the drive went in. Take a paver to a landscape supply yard and have it measured with a caliper if the stamp is worn. For the OEM versus aftermarket decision: IKO-branded units hold their color longer under the Fort Worth sun, but a quality aftermarket unit from a documented manufacturer can match dimensions and perform well at a lower material cost. We’ll give you the choice in writing before any work starts. If you’re also running KraftMaid, Cambria, or Silestone products elsewhere in the house, we’re already set up to source those brands too, but this page is about your driveway.
Styles & brands we work with
Signs Your IKO Driveway & Pavers Is Failing
- Pavers shifting or rocking underfoot. This means the bedding sand has washed out or settled, usually from poor drainage at the edge. The fix is lifting the affected units, re-screeding the sand, and addressing the base, not just resetting the paver on top.
- Water pooling after rain. IKO paver driveways are designed to drain. Standing water means the slope has flattened or the base has settled unevenly, and that water is working its way toward your foundation every time it storms.
- Edge restraint pulling loose. The plastic or aluminum edge along the driveway perimeter holds everything in compression. Once it cracks or separates, pavers start drifting outward within a season. This is the most common failure we see in Fort Worth’s clay soil, which expands and contracts harder than most homeowners realize.
- Cracks running through multiple pavers in a line. A single cracked paver is usually impact damage. A crack pattern that runs across several units in a straight or stair-step line points to a base failure underneath, and replacing only the cracked units won’t stop it from returning.
- Color fading or surface flaking across large areas. Fort Worth’s UV exposure is brutal on paver surfaces. If the color layer is delaminating, the units have reached the end of their useful life, and resealing won’t bring back what the sun already took.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Paver driveway installation in Fort Worth runs $7,000 – $18,000, and a full driveway replacement lands between $5,000 – $14,000. The spread comes down to square footage, how much of the existing base can stay, whether we’re matching an IKO pattern or starting fresh, and access to the site. A 400-square-foot paver drive with a good base runs toward the lower end of that range. A 1,200-square-foot drive with failed substrate, drainage corrections, and edge restraint replacement runs toward the top.
Every quote we write is a fixed, line-item price. No numbers that move at the door. The price includes demolition of the failed section, base repair or replacement, bedding sand, IKO-compatible pavers or edge components, compaction, and a clean site at the end. What it does not include is surprise change orders, because we don’t write them. Every completed job carries the 365-Day Done Right Promise: if the work fails inside a year, we return and correct it at no charge.
DIY or Call Us?
You can safely do the diagnosis. Walk the driveway after a rain and mark every spot where water pools. Sweep sand out of a joint and check how deep the base sits. Lift one edge paver and look at what’s underneath it. That information helps us quote accurately over the phone.
Where DIY goes wrong is the base. Fort Worth’s clay soil moves, and a paver driveway only performs as well as what sits beneath it. If you reset pavers on a failed base, you’ll be doing it again next spring. Edge restraint under tension is also not something to improvise; done wrong, the whole perimeter walks outward and the damage spreads. If the issue is cosmetic and isolated to a few units, we’ll tell you that straight and sell you the matching parts. If it’s structural, call us at (682) 204-4897 and we’ll give you a written price before any tools come off the truck.
FAQs
A properly installed IKO paver driveway on a competent base lasts 25 – 30 years in Fort Worth, though the surface may need re-sanding every 3 – 5 years and sealing every 5 – 7 years depending on sun exposure. The weak point is rarely the paver; it’s the base underneath, especially in clay soil that expands and contracts with the seasons. Call (682) 204-4897 and we’ll assess whether your base is still sound.
Yes, if the base under that section is intact and the existing IKO units can be matched by thickness and pattern. We repair partial failures regularly; what we won’t do is reset pavers on a base that’s already failed, because that repair won’t hold. Bring us a lifted paver and we’ll tell you whether a section repair makes sense.
Most full IKO paver driveway replacements in Fort Worth take 3 – 5 working days from demolition to final compaction, depending on size and access. Partial section repairs are typically done in one day. We’ll give you a written schedule when we give you the written price.
We keep common IKO-compatible paver units, edge restraint, bedding sand, and joint sand on hand for Fort Worth jobs, and we source specific patterns and thicknesses from local supply yards with a documented material trail. If you need a one-off match, we’ll measure what you have and bring the right units to the site.
Written by Curtis Lane, Owner, Bradford Remodeling Co Fort Worth at Bradford Remodeling Co Fort Worth, serving Fort Worth and nearby areas.
