Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Techo-Bloc Fence Installation: The Fort Worth Owner’s Guide
We stock and install Techo-Bloc fence systems throughout Fort Worth, with most complete fence installations running $3,500 to $9,000 depending on linear footage, panel style, and site prep. Most owners call us after a section of fencing has shifted, cracked at a post base, or begun leaning after a hard Texas storm. You’ll usually see the problem before you hear it: a gate that no longer latches square, concrete panels that have separated at the seams, or posts that have heaved out of true after a freeze-thaw cycle.
If you’re reading this, you’ve probably already walked the fence line and found the section that’s failing. We’ll tell you straight what it costs to make it right, and we’ll put that number in writing before we move a single panel.
Which Techo-Bloc Models This Applies To
Techo-Bloc’s fence and screening systems break down into a few main lines: the Blu 60 and Blu 80 freestanding and retaining wall blocks, the Mista and Raffinato stone panels when used as fence cladding, and the Yard and Estate post-and-panel systems that Fort Worth yards use most for privacy screening. The compatibility gotcha most homeowners miss: Techo-Bloc fence posts are engineered with a specific core dimension, usually 6-inch or 8-inch nominal, and the post block you buy for a 6-inch core will not seat correctly on an 8-inch base course. We measure post cores and panel tongues on site before quoting, because guessing at this stage means a fence that fights itself for its entire life.
On OEM versus aftermarket: Techo-Bloc’s factory fence blocks are high-compression concrete with a tighter color tolerance than most generics. That matters when you’re replacing one section of an existing fence in Fort Worth’s sun, because a mismatched block looks wrong from the street for years. We quote factory Techo-Bloc for matching work, and we’ll tell you when a quality aftermarket post or cap will save you money without compromising the fence line. Bradford Remodeling Co Fort Worth is an independent service provider. We are not affiliated with Techo-Bloc, but we install their systems enough to know what fits and what does not.
Styles & brands we work with
Signs Your Techo-Bloc Fence Installation Is Failing
- Posts leaning out of plumb. In Fort Worth’s expansive clay soils, post bases heave during wet-dry cycles and the post loses its bearing. You can sight down the fence line and see the bow before you feel it in the gate.
- Panels cracked at the tongue-and-groove joint. Freeze-thaw action from North Texas winters gets water into the groove, and the expansion pressure splits the panel edge. This usually starts as a hairline crack and opens over two or three seasons.
- Gate posts walking or twisting. A gate puts lateral load on the post every time it swings. If the post base was not set deep enough or the core was not filled, the post moves and the gate latch stops catching.
- Color fading or efflorescence spreading. White chalky deposits on the face of the block mean water is moving through the concrete. In Fort Worth’s hard-water climate, this can also indicate the backfill behind the fence is holding moisture against the panel.
- Bowed or bulging sections mid-run. Texas wind loads on a tall privacy fence will push a fence that was not reinforced. The panel stack can bulge between posts and eventually crack the top course.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Fort Worth, a full Techo-Bloc-compatible fence installation runs $3,500 to $9,000 installed. The spread depends on three things: how many linear feet you’re running, whether we’re pulling and resetting existing posts or setting new base courses, and which Techo-Bloc style you’re matching. A typical 40-foot privacy section with new posts and factory panels lands around $4,500 to $6,500. A longer run with gate work and post-core filling pushes toward the top of the range.
Every quote is line-itemed: materials, labor, base prep, haul-off of the old fence, and any concrete or gravel fill for post cores. No numbers move at the door. The work is covered by our 365-Day Done Right Promise: if the fence fails within one year of completion, Bradford returns and corrects it at no charge. You get that in writing before the job starts, signed by Curtis Lane, and you’re holding a copy at final walkthrough.
DIY or Call Us?
You can safely check post plumb with a 4-foot level, measure your linear run, and note where the panels are cracked so you can talk through the scope with us over the phone. What you should not do is pull a leaning Techo-Bloc post and reset it yourself. These posts are heavy, the fence panels above them carry weight, and a post that lets go mid-removal can take the whole section down with it. Fort Worth clay also complicates the reset: if you don’t backfill and compact the post base correctly, the new post will lean again inside a year, and now you’ve paid twice for the same fence section.
We show up with the right core fill, the right base depth, and a straight scope. Firm price, no surprises at final walkthrough. Call (682) 204-4897 and we’ll get someone out to look at the fence line and give you a written number.
FAQs
A properly installed Techo-Bloc fence in Fort Worth will last 25 to 40 years before the block itself degrades, but the post bases and gate hardware usually need attention at the 10 to 15 year mark because of clay soil movement and Texas wind. Call (682) 204-4897 if your fence is approaching that age and you’re seeing lean or latch problems.
Hairline cracks at the tongue-and-groove can sometimes be stabilized with epoxy injection, but once the panel edge is split through, the joint has lost its structural lock and the panel needs replacement. We’ll tell you which applies to your fence after seeing the crack in person.
Most Fort Worth residential fence sections take two to four working days, depending on how many posts need to be reset and whether gate hardware is being replaced. We give you a schedule in the written quote and we hold to it.
We keep common Techo-Bloc fence posts, caps, and panel replacements in our Fort Worth stock, and we can order factory color-matched blocks within a few days. In addition to Techo-Bloc, we work with KraftMaid, Cambria, and Silestone components on our other projects, so parts sourcing is something we handle daily. Call (682) 204-4897 to confirm we have your specific part on hand.
Written by Curtis Lane, Owner, Bradford Remodeling Co Fort Worth at Bradford Remodeling Co Fort Worth, serving Fort Worth and nearby areas.
